Where should the wire feed be set up for a pull?

The correct answer is that the wire feed should be set up closest to the section of conduit with the first bend.

This positioning is crucial because it helps to minimize friction and resistance when pulling the wire through the conduit. When the feed is located near the first bend, the wire can move more freely and reduce the risk of snagging or kinking as it travels through the bends. Properly aligning the wire feed in this manner ensures a smoother operation and aids in preventing potential damage to the wire or the conduit itself during the pulling process.

Setting the wire feed anywhere convenient may lead to complications, as it does not account for the angles and bends that the wire must navigate. Placing the feed at the end of the pulling section or at the beginning of the conduit does not provide the support needed to facilitate an efficient pull, especially around the initial bend where the wire is under the most stress. Thus, positioning the wire feed closest to the first bend is essential for an effective pull.